Alberta Plating Ltd.
3633 15a Street S.E T2G 3N5 Calgary, AB, Canada

Here is the bike Alberta Plating did the copper plating for the Harley Battle of the Kings competition https://customkings.harley-davidson.com/en_CA

Wood Stove Restoration that Alberta Plating did all the nickel for. Just a Lovely Old Stove

Here is a set of rims that we Nickel plated since we cannot get chrome in all the tighter corners.

Here is a sweet twisted motorcycle frame that we had polished and plated. Before twisting the metal the customer gave us the flat bar to polish and grind. Since it is difficult to polish after the twisting is done to remove pitting or imperfections in the tighter twists.

Here is a piece from a Chev that we had restored recently. it needed quite a bit of TLC and soldering... lots of soldering.

Here is a Motorcycle that we did in Shiny Nickel instead of chrome since chrome has trouble getting in all the corners.

All the detail on this little Eiffel tower came out great with the Antique Copper Finish we put on. And a before shot can be seen as well

if sending in parts via courier for plating. please fill out this form and enclose it with your parts. the areas in red are most important

Elevator door turned into a bathroom stall door/screen. Nickel plated by us.

More nickel plating on a this giant 5 foot diameter ring. We had to plate it 4 time over while rotating it to get the plating everywhere

Here is some hubcap repair and re chroming we did for a customer. I believe it was from an old Buick down in the USA

Here is candle holder that was damaged in shipping from over seas so we welded it and plated it nickel. The second candle did not survive the trip into Canada.

Some nickel plating that we did for a customer restoring a barber chair

Some bright chrome highlights on a rat rod we chromed the hub caps on. Also you can see the before and after

Here is some gold plating we did for the last episode of Hell On Wheels. Reads"The Transcontinental Railroad last spike, January 8 1868, completed May 10 1869"

Here are some tail lights that where completely rusted out on the inner and outer edges. You can look through the photos to see the stages it went though. Had to wrap them in copper then hammer/weld/replete several times to get to the final product.

Email from a recent customer: Good afternoon Anthony I just wanted to thank you again for the excellent job you and your crew did on the bumper for my ’56 Chev. I had my car in our annual car show, Rock-N-August, on the weekend and had many positive comments about it. Some said I should have parked my car nose-in because it looked better from the back than from the front.... Here’s a couple pictures of it installed. Thanks again, Gerry See more

Great bike that we worked on from Kanes Harley Davidson. Polish and Buffing the aluminum and chroming the pot metal.

Before and after Nickel plating Spoons and Knives made into insects

Finishes we Offer

Antique Copper Finish