Back Door Fab
In the shop Duncan, BC, Canada

Made a little set up today to covert the 79 ford from mech to hydro clutch only had to drill 2 holes for the master studs

Behind the scenes of every day work flow and chassis development / Dragon set up we have also been geeting everything rendered for the full product line website launch !

Charge pipes and adapters made from stock steel pipes and expanded exaust peices, welded a stick rod around the ends for a "lip" did the same thing with the coolant hoses

Back yard "billet" steering colume mount for the 79 hi boy

79 ford hi boy 12v swap coming along, things are going in for the final time

"RAM" rack and side steps for this minty first gen , ( some one mucked up his box after paint going back in to fix that )

GMC "hi clearance" winch ready bumper

@robson._82 got some slider/steps to go along with his rocker repair and rear bumper , front bumper next on the list

Fargo In for a fire wall and floor, check out what's under the hood

First shot at some real "body" work think.it turned out pretty good its all metal !

The coolest hunting sxs came in for some side step mods , supplier sent the wrong ones chopped em up to make them work

Another super duty rack clean no logos

Painted installed and loaded

Few pics of a rear bumper and full swing out set up befor it gets blended and cleaned up for paint

Stock toyota fender resi mounting to aftermarket resi canister all 1 peice "bolt in"

"Sealed" toyota tranny tunnel , boots are sika flexed to top plate sitting on foam tape and frame work caulked all they way around

Toyota rear disc swap kit "builder's special" this is the old school way using factory front brake components but in a all in one kit not just the brackets

Finally made some shop door handles iv been putting this off cause I knew I wanted to make something and couldn't bring my self to just buy regular handles from the hardware store